User Manual

24
WARNINGS
DO NOT place pendant under or between objects. This may unintentionally press the buttons and may
cause injury or damage.
Electronic equipment may be inuenced by Radio Frequency Interference (RFI). Caution should be exer-
cised with regard to the use of portable communications equipment in the area around such equipment. If
RFI causes erratic behavior, unplug the electric bed IMMEDIATELY. Leave unplugged while transmission
is in progress.
Ensure all cables and cords are routed such that they will not become entangled or pinched. Otherwise
damage or injury may result.
If a button on the pendant does not release or sticks, the bed spring will not stop moving.
If a liquid is spilled in or around the electric bed, unplug the electric bed before cleaning. Clean up the spill
and allow the electric bed or the area around the electric bed to dry thoroughly before using the electric
controls again.
Inspect the covering of the bed’s control panel and the patient control panel to assure that the covering is
not cracked or damaged.
Keep all electrical cords away from heated or hot surfaces.
Keep the cord away from heated surfaces.
NEVER operate if the unit has a damaged cord or plug. If it is not working properly, call a qualied techni-
cian for examination and repair.
NEVER operate this bed if it has a damaged cord or plug, if it is not working properly, if it has been
dropped, damaged, or dropped into water. Return the bed to a service center for examination and repair.
On Full Electric beds, the Hi/Lo crank MUST be removed before the bed is used. Failure to remove the
crank may cause damage or personal injury.
Refer servicing to qualied personnel only. Grounding reliability depends upon a properly grounded wall
outlet.
The pendant and power cords must be routed and secured properly to ensure that the cords DO NOT
become entangled, pinched and/or severed during operation of the electric bed.
Unplug from the outlet before servicing.
Unplug the power cord from its power source before performing any maintenance on the manual/electric
bed. DO NOT unplug the power cord from the junction box. Damage to cord will result.