Specifications

1BHFt%3*45&&.)VNJEJUFDI&MFDUSJD)VNJEJGJFS*OTUBMMBUJPO0QFSBUJPOBOE.BJOUFOBODF.BOVBM
5BQTPGUFOFEXBUFS
Table 38-1:
Humidi-tech torque specifications
Screw or lug location Torque
Power block 1.8 N-m
Contactor 1.8 N-m
Heater
nut
8.5 mm nut 2.2 N-m
9.5 mm nut 2.8 N-m
Heater
wire lug
10 mm
2
wire 4.0 N-m
6 mm
2
wire 2.8 N-m
<6 mm
2
wire 2.2 N-m
t *OTUBMMUIFQSPCFBOEQSPCFQMVHBTTFNCMZ7FSJGZHSPVOE
wire is solidly connected to tank.
t 4FDVSFUIFDIBNCFSDPWFSNBLJOHTVSFUIFDPWFSHBTLFUJT
seated and the chamber is sealed.
t 3FJOTUBMMFWBQPSBUJOHDIBNCFS
– Reconnect the fill line.
– Reconnect electrical plugs (the plugs are color coded).
– Reconnect the drain union.
– Reconnect the vapor hose.
t 7FSJGZFMFDUSJDBMDPOOFDUJPOT
– Verify that all DIN rail-mounted components are
securely fastened to DIN rail.
– Verify that all power terminal screws and lugs are tight
from power block to heaters. See torque specifications in
Table 38-1.
– Verify that all plugs under the humidifier cover are
completely plugged in.
t .PWFUIFESBJOWBMWFMFWFSCBDLUPUIFBVUPQPTJUJPO
t 5VSOPOUIFXBUFSTVQQMZ
t 5VSOPOUIFFMFDUSJDBMQPXFS
3. 0GGTFBTPONBJOUFOBODF
t 1FSGPSNDPNQMFUFJOTQFDUJPOBOEDMFBOJOHPGUIFGPMMPXJOH
– Heaters
– Probe rods
– Skimmer port and water seal
– Humidifier tank
t "GUFSDMFBOJOHUIFIVNJEJGJFSTIPVMESFNBJOFNQUZVOUJM
humidification is required.
Maintenance