Specifications

%3*45&&.)VNJEJUFDI&MFDUSJD)VNJEJGJFS*OTUBMMBUJPO0QFSBUJPOBOE.BJOUFOBODF.BOVBMt1BHF
Follow the instructions below for your wall type, and mount the
humidifier level and plumb. See Figures 8-1 and 9-1.
t 8PPETUVETNNPODFOUFS
.BSLIPMFMPDBUJPOTBUUIFDFOUFSTPGUIFTUVETBOEQSFESJMM
(6 mm) diameter pilot holes. Secure the cabinet to the wall with
the lag bolts (provided).
t .FUBMTUVETNNPODFOUFS
.BSLIPMFMPDBUJPOTBUDFOUFSTPGTUVETBOEESJMMNN
IPMFTUISPVHIUIFTUVETBOEXBMM1VTIBNNCPMU
through the wall, the studs, and a backing plate on the other side
of the wall. Secure the cabinet to the wall with a nut and washer.
t *GNNPODFOUFSTUVETBSFOPUBWBJMBCMF
Mount spanner boards on the wall, spanning two studs. Locate
one board at the top of the cabinet (for the lag bolts) and the
PUIFSCPBSENNPODFOUFSGSPNUIFCPUUPNPGUIF
cabinet. Secure the cabinet to the spanner boards.
t )PMMPXCMPDLPSQPVSFEDPODSFUFXBMM
Mark hole locations, and drill appropriate pilot holes for two
NNUPHHMFCPMUTPSUXPNNNBDIJOFCPMU
lead anchors. Secure the cabinet in place with the bolts and
anchors.
.PVOUJOHUIFIVNJEJGJFS
Installation
Figure 7-1:
Humidi-tech clearance recommendations
Top (when SDU is not mounted directly above
the Humidi-tech): 460 mm
Right side electrical
controls: 915 mm
Supporting wall
Front 915 mm
Floor: 610 mm
Left side:
305 mm
Secured to supporting
wall
To dispersion
assembly
DC-1201
Maintain these clearances for service and maintenance.
WARNING
Mounting hazard
Mount humidifier per the instructions
in this manual and to a structurally
stable surface. Improper mounting of
the humidifier can cause it to fall or tip,
resulting in severe personal injury or
death.