Installation guide
1BHFt%3*45&&.7BQPSMPHJD
3
Installation and Operation Manual
Table 88-1:
Vapor-logic
3
troubleshooting guide
Problem Possible cause Action
Drain fault
When in automatic drain
sequence or end-of-season drain,
Vapor-logic
3
allows 20 minutes
for the water level to drop from
the top probe to below the
lowest probe (for standard water
units) or to the low-water switch
level (DI water units with end-
of-season drain). If the tank does
not drain to this level in the time
allotted, a fault is indicated.
t 5BOLESBJOPVUMFU t *GUIFIVNJEJmFSUBOLESBJOPVUMFUJTQMVHHFEDMFBO
t 8BUFSEFUFDUJPOQSPCFT t $MFBOQSPCFPSSFQMBDFQSPCFSPEBTTFNCMZ
t %SBJOWBMWFXJSJOH t $IFDLESBJOWBMWFXJSJOH
t $IFDLUPCFTVSFESBJOWBMWFJTXJSFEUPUFSNJOBMTBOE
on control board.
t 3FTFU7BQPSMPHJD
3
.
t 'JMMWBMWF t $IFDLGPSWPMUBHFQSFTFOUBUUIFWBMWF*GQSFTFOUDMFBOPS
replace valve.
t 3FQMBDFmMMWBMWFJGXBUFSJTMFBLJOHUISPVHI
t 4ZTUFNQSPHSBNNFEGPSNBOVBM
drain
t 3VOBUFTUDZDMFUPTFFJGUIFTZTUFNBDUJWBUFTESBJOPVUQVU
t %SBJOMJOFCBDLJOHVQXJUIXBUFS
t %SBJOMJOFQMVHHFE
t *OTVGmDJFOUESBJOMJOFQJUDI
t *OTVGmDJFOUESBJOMJOFTJ[F%/JTNJOJNVN
diameter for drain line lengths over 10' (3 m)
Tank level fault (Tank Level Flt)
QSFWJPVTOBNF'JMM5JNF'MU
t 'JMMWBMWFJTTUVDLPQFO t $IFDLWBMWFGPSGPSFJHONBUUFS
t 'JMMWBMWFJTJOTUBMMFECBDLXBSE t $IFDLBSSPXEJSFDUJPOPOWBMWFPS”In” should be visible
on fill valve body.
t &YDFTTJWFDPOEFOTBUFJTESBJOJOH
into the tank.
t $POTVMU%3*45&&.UPJODSFBTFUIFBNPVOUPGXBUFSUIBU
can be converted to steam before receiving a fault.
Boil time fault t 'BVMUZUBOLUFNQFSBUVSFTFOTPS
t %JNJOJTIFEPVUQVU
t5BOLJTOPUJOTVMBUFE
t 7FSJGZUBOLUFNQFSBUVSFTFOTPSJTGVODUJPOJOHDPSSFDUMZBOE
is affixed to the tank; 70 ºF (27 ºC) measures 1000 ohms.
t 4FF
“Reduced or no output” entry in this troubleshooting
guide.
t5FNQFSBUVSFNVTUSFBDI¡'¡$JONJOVUFT
Insulate tank.
More on next page ▶
Troubleshooting guide
xreftag
xreftag
xreftag
VL3_IOM.pdf 92 11/19/2009 9:11:16 AM










