Installation guide
DRI-STEEM Vapor-logic
3
*OTUBMMBUJPOBOE0QFSBUJPO.BOVBMt1BHF
Main menu: Reports screen
Reports
The Reports menu displays up to four report options to help the
user gain historical data on the humidification system. Information
contained in each report is explained below. The Reports menu is
not available with Vapor-logic
3
versions 5.x.x and 7.x.x (systems
with multi-tank configuration capability).
Water usage report
The Water Used report displays how many pounds (kilograms)
have been converted to steam in the humidifier. For Vapor-logic
3
versions 3.0.1 and higher, reset this total from the water usage
report screen by pressing the Reset soft key. The date the water
usage was reset last also appears on the report. For Vapor-logic
3
versions previous to 3.0.1, the water usage report is reset when the
service interval is reset from the Set Up menu.
Energy usage report
The Energy Used report displays how much energy was consumed
by the humidifier. Depending on the system type, this number
may be in kWh, MBtu, therms, etc. For Vapor-logic
3
versions 3.0.1
and higher, reset this total from the energy usage report screen by
pressing the Reset soft key. The date the energy usage was last reset
also appears on the report. For Vapor-logic
3
versions previous to
3.0.1, the energy usage report is reset when the service interval is
reset from the Set Up menu.
RH/dew point history report
The RH (or dew point — depending on system configuration)
history report provides a way to track minimum and maximum RH
or dew point. To allow trending over a desired interval of time, reset
this data at any time by pressing the Reset soft key. The date the RH
or dew point history was reset last also appears on the report. Use
the Back soft key to return to the Reports menu. Use the Main soft
key to return to the Main Menu. The history report is disabled on
systems with an external control signal by others.
VL3_IOM.pdf 83 11/19/2009 9:11:16 AM