Installation guide
Page 4 • DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual
mc_050808_1005
Carbon monoxide, fire, explosion, and electrical shock hazards.
Improper installation, adjustment, alteration, service, maintenance, or 
use can cause carbon monoxide poisoning, fire, explosion, electrical 
shock, and other hazardous conditions. These hazardous conditions 
could cause personal injury, property damage, or death. To prevent 
hazardous conditions, read all warnings; lock all power disconnect 
switches in the OFF position before removing any access panels; and 
consult a qualified installer, service agency, local gas supplier, or 
your distributor or branch for information or assistance. The qualified 
installer or agency must use only factory authorized and listed kits or 
accessories when modifying this product. 
• Inspect humidifier and accessories upon arrival for damaged, missing, 
or improper parts. If there is a problem, call DRI-STEEM.
• Application of this humidifier should have special attention given to 
vent sizing and material, gas input rate, and unit sizing. Improper 
installation or misapplication of the humidifier can cause excessive 
servicing or permanent component failure.
• When working on equipment, observe precautions in literature, tags, 
and labels attached to or shipped with the unit and observe other 
safety precautions that may apply. Wear safety glasses and work 
gloves. Have a fire extinguisher available during start-up, adjustment 
procedures, and service calls.
• Do not use this appliance if any part has been under water. 
Immediately call a qualified service technician to inspect the 
appliance and to replace any part of the control system and any gas 
control that has been under water.
• Do not lift humidifier by gas controls, gas manifold, fire box, or 
shroud.
• Should overheating occur, or the gas supply fail to shut off, shut 
off the manual gas valve to the appliance before shutting off the 
electrical supply.
• The evaporating chamber is designed as a non-pressurized vessel. 
DO NOT restrict piping where steam exits the humidifier. 
Install drain piping and piping that connects the evaporating 
chamber to the dispersion assembly only as described in this manual. 
DO NOT install a shut-off valve on the piping connecting the 
evaporating chamber to the steam outlet. 
• Check the humidifier name plate for the gas type indicated (natural 
gas or propane gas). Supply the humidifier only with the gas type 
indicated, or burner failure will result. To convert the humidifier to a 
different gas type, contact DRI-STEEM technical support or your local 
DRI-STEEM representative/distributor.
Safety precautions
WARNING!
More safety precautions are on the next page ▶
Overview










