Use and Care Manual

Drinkpod LLC 888 852 7873
www.drinkpod.com
7
Installing The ConstantBrew Water Line
Installation Overview
Are you ready to impress your significant other, parents, or cat with your mad plumbing skills
with ease? Let’s get started!
Directly below, we’ve provided the option for a shortcut installation method. It requires that you
have a ‘plastic’ water line (not copper or braided stainless steel) and don’t mind cutting it.
However, if you need to be able to disconnect everything and return it to it’s initial state (i.e. if
you rent or lease) continue on to the standard installation method on the next page.
Accelerated Installation Method (unreversible)
1. Identify and turn off water source.
2. Choose where you want to splice into your water line and slice it at a 90 degree angle (it
helps to put a towel below to catch the dripping water).
3. Remove the short run of tubing attached to Connect Point B1 on Assembly 1 (see below).
4. Connect one end of your spliced ice maker water line to where you removed the tubing
(Connect Point B1) and connect the other end to Connect Point C1.
5. Remove the transparent plastic cap from the reservoir on your JavaPod, and replace with the
ConstantBrew system.
6. Insert the tubing from (Connect Point A) to the port on the back of the ConstantBrew
system.
7. Turn on the water source and the shutoff valve on Assembly 1.
8. Read the instructions for using the ConstantBrew system.
Assembly 1
Connect Point (A)
Connect Point (B1)
Connect Point (C1)