Use and Care Manual
Installing Your Drinkpod
Installing Your Drinkpod 2-27
Flushing Your Filters
Certain types of lters require ushing prior to use. This ensures any loose carbon
particles in your lter media are discharged prior to drinking. ALWAYS ush newly
installed lters, prior to drinking. For your kit, the two specic lters that need ushed are
F1
Chemical Scrub and
F3
Polishing Scrub.
1. Place a container of water under one of the dispensers.
2. Proceed to dispense the full contents of each tank plus one gallon (to allow for the rest
of the internal water system). See the total volume for each below.
Mode/Tank Capacity To Flush
Cold (+ Reserve) 0.9 GAL (3.5 L) + 1.06 GAL (4 L) +1 GAL (3.79 L)
≈ 3 GAL (11
L)
Hot 0.26 GAL (1 L) +1 GAL (3.79 L)
≈ 2.5 GAL (9 L)
Enabling Water Flow From Your Drinkpod (Optional)
1. If you have connected accessory appliances, you can now open the
C
1/4 in. Quick Connect Shuto Valve connected to your Accessory Line. Water
should now start owing into your accessory appliances. Check the lines, valve, and
appliances for leaks.
2. Once you here the water stop owing, you can plug your accessory appliances back in
and power them on. If possible, ush water through each for 1 minute.
Powering On Your Drinkpod
Congratulations! You’re nished! You may now proceed to power
on your DRINKPOD. For details on how to use and maintain your
Drinkod, see the Use & Care Guide for instructions.