Use and Care Manual

Installing Your Drinkpod

Installing Your Drinkpod 2-26

Enabling Water Flow To Your Drinkpod

1. If it’s not already open, start by opening your Water Source Valve (the valve on your

existing water source we rst shut o)see ”Turning On Your Water Source” on page

2-24.

2. Ensure nothing is leaking between or at either of the valves.

3. Now open the valve on the

1/4 in. Quick Connect Shuto Valve on your

Water Input Line as shown below.

Diagram 2.9.3 - Open Shuto Valve

4. You should hear water running and lling the DRINKPOD’s tanks. Check for leaks, and

wait until the sound of water running stops.

5. Once the DRINKPOD is lled, plug it in. DO NOT FLIP ON THE POWER SWITCHES

OR CONNECT ACCESSORY LINE YET!

6. We need to ush each temperature mode. For the best experience, we recommend

ushing the full tank capacity for both the Hot Mode and Cold Mode.