Use and Care Manual
Installing Your Drinkpod
Installing Your Drinkpod 2-23
Connecting Your DRINKPOD
Congratulations! You are now close enough to the end that you should be able to taste it.
You should now have a water line running from either under your kitchen sink or your ice
maker hookup to wherever you plan on locating your new DRINKPOD 2000. From here on
our, we will refer to this line as your Source Line.
If your Ice/Coee Connect feature, you should also have another line from your Accessory
Appliance, or 1/4 in. Brass Compression Tee if you have 2 Accessory Appliances. We will
refer to this as your Accessory Line.
1. Move your new DRINKPOD 2000 to its nal location. Do not plug the power cord in yet.
2. Remove the plug from the
M
Water Input Line.
3. Insert the open end of
A
1/4 in. White PP Tubing (the small segment of tubing after
the
C
1/4 in. Quick Connect Shuto Valve) on your Source Line into the
M
Water Input Line attached at the end of located at the back of your DRINKPOD on
the right side.
L
M
Diagram 2.7.1 - Connect Source Line To Source Input Port
4. Continue to rmly insert tubing into opening until it won’t go any further. Then pull tubing
backwards (away) from valve, using medium force, to engage/extend the compression
sleeve on the valve, and ensure the connection is secured.