Use and Care Manual
Installing Your Drinkpod
Installing Your Drinkpod 2-20
power on your accessory appliance.
To connect Quick Connect Tubing to the
E
1/4 in. Brass Compression Tee,
unscrew the compression nut (from the port specied in the applicable diagram
below), and thread the Quick Connect Tubing through it. Then, insert the Quick
Connect Tubing into the threaded port of the Brass Compression Tee, and screw the
compression nut back onto the port with your hand. Finally, tighten the connection with a
1/2 in. wrench or pliers.
To connect a Female Compression Hose, simply remove and set aside the
compression nut (from the port specied in the applicable diagram below), and screw
the Female Compression Hose directly onto the port, using a 1/2 in. wrench or pliers to
tighten.
Diagram 2.6.5-A - Merging Connections to Brass Compression Tee For 2 Accessory Appliance Conguration