Use and Care Manual

Getting Started
Getting Started 1-8
Preparation
Before we start tapping your water source, there are a few items you need to grab that
weren’t included in your installation kit.
• Sharp Knife or Scissors
• Pliers, or Adjustable Wrench, or Open-End 7/16 in. Wrench (all installations),
1/2 in. Wrench (most installations), and 11/16 in. Wrench (*sink water source
installation only)
• Container To Drain Water Into (i.e. bucket, bowl, or pitcher)
• Flashlight or Lamp (if under sink installation area is poorly lit)
• Drill (if drilling holes to run tubing is required)
or or or
+
1/2 in.
+
7/16 in.
11/16 in.
*
Diagram 2.0.1 Additional Items Needed For Installation
1. Remove the DRINKPOD and lters from the packaging and set them aside.
2. Let’s get started. If your plan is to utilize your Accessory Water Line as your source,
proceed to Option A (Accessory Water Line). If you plan to use your sink’s cold water
lin, turn to “Option B: Tapping Faucet Cold Water Line” on page 2-5.