Operating Guide

Step 16
Use scissors or knie
to cut approximately
1’ section off the end
of
A
25’ x 1/4” PVC
tubing at a 90° angle.
Step 18
Firmly pull
outward on both
ends of tubing, to
extend quick-
gripping seals on
shutoff valve. Ensure
valve is closed.
Step 17
Connect one end of new tubing section, into one
end of
C
1/4” Shutoff Valve, and free end of
A
25’ x 1/4” PVC tubing, into the other end. Firmly
push the tubing into the push-fitting until you
cannot push it any further. Some resistance is
normal.
This valve is what
you’ll use to locally
shut off water to your
Drinkpod for tasks
like relocation, or
swapping filter.
16
Before You Continue
In our next steps, we will
connect and setup your
new Drinkpod. Before
proceeding, please ensure
that
A
25’ x 1/4” PVC
can reach from your water
source to the Drinkpod.
Should this require drilling
holes along the path, please
proceed with caution, and
at your own risk. If you do
not feel qualified, please
contact a professional
plumber, or give us a call, so
that we may recommend an
installation technician.
Step 15
Ensure Drinkpod is
located where you
plan to use it, and
that
A
25’ x 1/4” PVC
tubing has been laid
so that it reaches
M
Water Inlet with at
least several feet of
slack.
Make sure Drinkpod
is turned off and
unplugged from
electrical outlet.
15