Operating instructions
Installation
Mounting the Display Console
Select a mounting location which seems most workable,
and that best ts your needs. It should be convenient
to reach and highly visible to the operator. DO NOT
INSTALL IN A POSITION THAT OBSTRUCTS THE
VIEW OF THE ROAD OR WORK AREA. Whenever
possible, avoid locations that expose the console to
direct sunlight, high temperature, strong chemicals or
rain. Place the mounting bracket in selected location,
mark holes, drill 1/4” (7mm) holes and mount bracket
with bolts, lockwashers and nuts provided. (Use self-
tapping screws if not practical to use bolts.) See
Illustration 1A. Put rubber washers on carriage bolts
and put the bolts through the bracket holes from the
inside out. Loosely attach the mount knobs onto the
bolts. Place console over carriage bolt heads and tighten
knobs to secure the console. See Illustration 1B.
5. Attach the quick disconnects on the
switch harness to the switch. The RED wire
should attach to the top connection with the
BLACK attaching to the bottom connection.
6. Install the switch harness connector into the
mating connector (gray tie) on the console harness.
NOTE: If using the included Power On/
Off switch instead of the ignition switch
connection, install the power switch as
described above. Connect the power
switch cable connector (2 pin) to the
mating connector on the console harness.
Mounting the Run/Hold Switch Kit
Remove the mount knob from either side of the
console. Install the bracket over the carriage bolt
and along side the console bracket. Install the mount
knob on the carriage bolt and tighten to secure
the console and run/hold switch bracket in place.
Install the switch into the bracket using the steps below:
1. Place the small washer on the switch followed
by the at “notched” washer. See Illustration 2.
2. Secure the washers in place with one of the hex nuts.
3. Peel the back from the decal and secure to the
front of the switch bracket. See Illustration 2.
4. Install the switch in the bracket and secure
in place with the remaining hex nut. NOTE:
Make sure the “ON” connector is at the top.
Attaching the Power and Run/Hold Control Switches
CrustBuster
DrillMaster Quick Start Guide
346-001150 Pg 4 Revised 11/2010