Operating instructions

CrustBuster
DrillMaster Quick Start Guide
346-001150 Pg 13 Revised 11/2010
In-Field Operation in AUTO Mode
1. Switch on tractor hydraulics.
2. Turn on all Section switches located on the top of the Drillmaster controller.
3. Push AUTO/MAN button until AUTO is displayed on Drillmaster display screen.
4. Switch RUN/HOLD toggle switch to RUN.
5. Drillmaster controller and drill hydraulic drive should now be ready for AUTO eld operation. Drill should
now operate only when openers are down and tractor is moving.
CROP TYPE SLOT
WIDTH
TARGET
RATE
CAL NUMBER JACKSHAFT
SPROCKET-C
SPROCKET ON HEX
SEED SHAFT-D
Table to Record Your Own Data and Calibration Numbers
Sprocket Locations