MSDS

Page 2 of 2
Date of Preparation: 14-08-18
MATERIAL SAFETY
DATA SHEET
Use in case of an emergency only [phone]
2W1633
CHRONIC EFFECTS OF OVEREXPOSURE FETOTOXICITY/TERATOGENECITY/MUTAGENECITY IRRITANT SENSITIZER
Prolonged or repeated contact with skin will cause
irrritation, defatting, dermatitis. Respirable dust may
cause lung disease (Silicosis) and possibly cancer.
Not Data Available YES: Skin
SECTION VI - REACTIVITIY DATA
STABILITY: HAZARDOUS POLYMERIZATIONS:
Stable Will not occur
INCOMPATABILITY: (Materials to avoid) CONDITIONS TO AVOID:
Heat and Oxidizing compounds Excessive heat and freezing temperatures.
HAZARDOUS DECOMPOSITION PRODUCTS:
Oxides of Carbon
SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN in case material is Released or Spilled WASTE DISPOSAL METHOD
SECTION VIII - SPECIAL PROTECTION INFORMATION
PERSONAL PROTECTION EQUIPMENT
PROTECTIVE GLOVES: EYE PROTECTION:
OTHER PROTECTIVE EQUIPMENT:
RESPIRATORY PROTECTION:
ENGINEERING CONTROLS - VENTILATION:
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING OTHER PRECAUTIONS
YES: Skin, Eye and
Respiratory Tract
CARCINOGENECITY
Crystalline Silica is IARC
and NTP listed as
carcinogen. Titanium
Dioxide is IARC Group 2B
listed - possible human
carcinogen based on
inadequate evidence on
humans and sufficient
evidence in experimental
animals.
Restrict access to area. Remove all sources of ignition. Ventilate area. Sweep up spilled material and place material into a closed container. If a
large spill, dike area to prevent this material from entering water systems or sewers. Wash away residue with water. Wear protective equipment
during cleanup.
Dispose of this material in accordance with Federal, Provincial, and
Municipal regulations.
Chemical reistant gloves made of Viton should be used. Gloves made of nitrile, neoprene or rubber
may be used for exposure of short duration.
Not normally required. When sanding or abrading dried film, wear a dust/mist respirator approved by NIOSH for dust which
may be generated from this product, underlying paint, or abrasive.
Chemical safety goggles should be worn to prevent eye contact.
Wear protective clothing to prevent skin contact.
General (dilution) ventilation is required during normal use. Local exhaust ventilation may be required during
certain operations to keep exposure level below the limit listed in Section II of this data sheet. Contains
extremely flammable solvents. Take suitable fire precaution.
STORAGE: Keep storage area separate from populated work areas. Store in a cool, dry, well ventilated area, out of direct sunlight and away
from incompatible materials and any source of ignition. PROTECT FROM FREEZING.
HANDLING: Avoid prolonged or repeated inhalation of vapours or spray mist. Avoid prolonged or repeated skin contact.