Installation Guide

DRICORE
™
PRO CONCRETE REPAIR CARBON FIBER
REINFORCEMENT KIT INSTRUCTIONS
PLEASE READ ALL DIRECTIONS CAREFULLY & WEAR SAFETY GOGGLES BEFORE INSTALLING
01
© DRICORE
®
All Rights Reserved
WWW.DRICORE.COM1-866-767-6374
KIT INCLUDES MATERIALS TO REPAIR 1 WALL CRACK
• (1) 10" wide x 8' long unidirectional, horizontal carbon fiber strip
• (2) Tubes of DRICORE
™
PRO Concrete Repair Adhesive Epoxy
• (2) DRICORE™ PRO Concrete Repair Static Epoxy Mixing Nozzles
2311 Royal Windsor Drive
Mississauga, ON L5J 1K5
P: [phone]
E: [e-mail]
Preparation
1
• Safety Goggles
• Scissors
• Safety Mask
• Marker
• Plastic Putty Knife
TOOLS NEEDED
10-Gallon HEPA Dust Extractor
Collects dust while attached to
grinder and shroud tools
Grinder equipped with 5-inch
surface grinding dust shroud kit
RECOMMENDED TOOLS
Use for grinding foundation wall
*USE DIAMOND CUP WHEEL
SAFETY WARNINGS
Please read and follow safety procedures for all tools and wear proper safety equipment during installation.
While using power tools follow all EPA/OSHA guidelines for lead paint removal and respiratory protection. For more information visit www.epa.gov
or www.osha.gov. Please refer to dricore.com for safety data sheets.
Hammer Drill
Use for concrete removal
*USE CHISEL OR SPADE TIP ATTACHMENT
• Locate where the DRICORE™ PRO Concrete Repair Carbon Fiber
Reinforcement Kit will be installed
• Mark the crack at the top, middle and bottom of the wall
• Mark 6 inches (15 cm) on both sides of the crack at top, bottom and
middle locations
Tools:
Measuring tape, marker
• Hammer
• Epoxy Gun
• Measuring Tape
• Gloves
PRODUCT COMMONLY USED WITH CRACK REPAIR
DRICORE
™
PRO
CONCRETE REPAIR
CRACK INJECTION
KIT
230719
TM