Installation Guide

02
2311 Royal Windsor Drive
Mississauga, ON L5J 1K5
P: [phone]
E: [e-mail]
© DRICORE
®
All Rights Reserved
WWW.DRICORE.COM1-866-767-6374
DRICORE
™
PRO CONCRETE REPAIR CRACK INJECTION KIT
INSTRUCTIONS
Cover the crack
4
• Dispense approximately 1/3
rd
of the tube of the
DRICORE™ PRO CONCRETE
REPAIR CRACK PREP SURFACE PASTE onto the disposable work surface (like card
board). Add more as needed. Epoxy should be hand mixed prior to application with a
plastic putty knife
• Apply the DRICORE™ PRO CONCRETE REPAIR CRACK PREP SURFACE PASTE over
the entire crack, ensuring there are no gaps for the polyurethane to leak out during
injection
• Feather the epoxy approximately 2 inches (5 cm), or more, on both sides of the
crack
• At port locations, apply the epoxy around the entire port until the port base is no
longer visible
Tools: Gloves, disposable work surface, plastic
putty knife
Injection
5
• Once DRICORE™ PRO CONCRETE REPAIR CRACK PREP SURFACE PASTE (used to
seal the crack and set the ports) has initially cured after approximately 2-3 hours, the
crack is ready to inject
TIP: If a screwdriver can dent the epoxy, it is NOT fully cured. Environmental
conditions play a role in how long it takes to cure, and a hardness test should be
done prior to injection
• Insert DRICORE™ PRO CONCRETE REPAIR CRACK INJECTION EXPANDING FOAM
into the caulking gun, remove cap, and screw on nozzle
• Starting at the bottom port, push the static mixing nozzle into the port until you
feel a click
• Dispense the product slowly until you see it coming out of the next highest port.
Remove nozzle and close off the port with the cap. Please note that injection may
take up to 4 minutes or longer per port; the tighter the crack, the longer the
polyurethane will take to flow into it. Patience is key!
• Insert into the next port and repeat the process working your way along the crack,
port by port
Tools: Gloves, safety glasses, safety mask, caulking gun, port caps
Clean Up
6
• Once DRICORE™ PRO CONCRETE REPAIR CRACK PREP SURFACE PASTE and
DRICORE™ PRO CONCRETE REPAIR CRACK INJECTION EXPANDING FOAM have
cured, remove the ports from the wall using a hammer. It may take 12-24 hours for
the epoxy to cure before you can remove the ports
• Patch port locations with DRICORE™ PRO CONCRETE REPAIR CRACK PREP
SURFACE PASTE
Tools: Hammer
TM