Installation Guide

02
2311 Royal Windsor Drive
Mississauga, ON L5J 1K5
P: [phone]
E: [e-mail]
© DRICORE
®
All Rights Reserved
WWW.DRICORE.COM1-866-767-6374
DRICORE
™
PRO CONCRETE REPAIR CRACK INJECTION KIT
INSTRUCTIONS
Port Locations
2
• Mark port locations approximately every 6 to 12 inches (15 to 30
cm) starting from the bottom of the crack; the tighter the crack, the
closer the ports should be. For a typical 8 inch (20 cm) thick concrete
wall, ports should be installed every 8 inches (20 cm) and no closer
than 6 inches (15 cm). Thinner slabs may allow for 12 inch (30 cm)
spacing
Note: Additional ports may be required for cracks with multiple
locations
Tools: Marker and measuring tape
Port Installation
3
Start within 4 inches (10 cm) of the bottom of the crack and mark your port locations along
the crack every 6 to 12 inches (15 to 30 cm).
• Detach port cap from the side of the port and set aside. Do not discard the port plugs as they will
be used later in the installation
• Wearing gloves, insert the cartridge into a heavy duty caulking gun with a minimum thrust ratio
of 10:1
• Dispense a small amount of DRICORE
™
PRO CONCRETE REPAIR CRACK PREP SURFACE PASTE
onto a disposable work surface, such as cardboard or painter’s tray. Epoxy should be hand mixed
prior to application with a plastic putty knife
• Roll the entire flat edge of the port in the DRICORE
™
PRO CONCRETE REPAIR CRACK PREP
SURFACE PASTE
• Make sure the hole for the port is not plugged with epoxy
• Pressing firmly, place the port directly over the crack at previously marked locations
• The final port location needs to be below the outside grade of the structure
• Small cracks coming off the main crack will need to be covered with DRICORE
™
PRO CONCRETE
REPAIR CRACK PREP SURFACE PASTE
Hint: To get the epoxy to set quicker, rapidly mix by hand after dispensing
Note: Tubes may not appear to be completely filled due to the filling process; the quantity stated on the label is correct
Tools: Gloves, disposable work surface, ports
01: Roll the i
njection port in DRICORE
™
PRO
CONCRETE REP
AIR CRACK PREP SURF
ACE P
ASTE
02: Press injection port firmly directly over the crack
03: Cover over previously marked locations
TM