Installation Guide

DRICORE
™
PRO CONCRETE REPAIR CRACK INJECTION KIT
INSTRUCTIONS
PLEASE READ ALL DIRECTIONS CAREFULLY & WEAR SAFETY GOGGLES BEFORE INSTALLING
01
© DRICORE
®
All Rights Reserved
WWW.DRICORE.COM1-866-767-6374
KIT INCLUDES MATERIALS TO REPAIR 1 WALL CRACK
• (1) Tube of DRICORE
™
PRO Concrete Repair Crack Prep Surface Paste
• (1) Tube of DRICORE
™
PRO Concrete Repair Crack Injection Expanding
Foam
• (2) DRICORE
™
PRO Concrete Repair Static Epoxy Mixing Nozzles
• (10) DRICORE
™
PRO Concrete Repair Injection Ports
2311 Royal Windsor Drive
Mississauga, ON L5J 1K5
P: [phone]
E: [e-mail]
Preparation
1
• Gloves
• Scissors
• Marker
• Hammer
• Drop Cloth or Cardboard
• Safety Goggles
• Safety Mask
• Wire Brush
• Plastic Putty Knife
• Epoxy Gun (10:1 Thrust)
• Measuring Tape
TOOLS NEEDED
SAFETY WARNINGS
Please read and follow safety procedures for all tools and wear proper safety equipment during installation.
While using power tools follow all EPA/OSHA guidelines for lead paint removal and respiratory protection. For more information visit
www.epa.gov or www.osha.gov. Please refer to dricore.com for safety data sheets.
• Examine the crack that is being repaired
• Lay drop cloth or cardboard on the floor
• Clean the crack and immediate surrounding areas with a wire brush
or optional tools if the area requires further preparation
Note: Each kit will fix approximately one wall crack that measures 4-5
feet long, 1/16 to 1/8 inches wide and 8 inches deep (121-152 cm
long, 0.15 to 0.31 cm wide and 20 cm deep)
Tools: Marker, wire brush, plastic, drop cloth or cardboard, (optional)
tools for crack prep
PRODUCT COMMONLY USED WITH CRACK INJECTION
DRICORE™ PRO Concrete
Repair Carbon Fiber
Reinforcement Kit
10-Gallon HEPA Dust Extractor
Collects dust while attached to
grinder and shroud tools
OPTIONAL TOOLS FOR CRACK PREP ONLY
Grinder equipped with 5-inch
surface grinding dust shroud kit
Use for grinding foundation wall
*USE DIAMOND CUP WHEEL
Hammer Drill
Use for concrete removal
*USE CHISEL OR SPADE TIP ATTACHMENT
TM