User Manual

07-01674K F410, F411 10 Dri-Eaz Products, Inc.
ERROR MESSAGES
If the control system detects an error, it will produce an error (“ER”) message. If this occurs, first unplug the unit and then
plug it back in. This will usually reset the electronics, and the unit will begin operating normally. If the error message
reappears, refer to the explanations and solutions shown below. If these solutions do not fix the problem, contact your
local authorized service center.
C O N T R O L P A N E L
M E S S A G E
E X P L A N A T I O N A N D S O L U T I O N
ER4 DEFROST
SENSOR CONNECT
or
ER4 OULET
SENSOR CONNECT
Temp sensor is open, missing, or shorted. Check that temp sensors are installed
correctly on control panel. If error persists, contact service.
ER5 SENSOR
CONNECTION ON BD
Inlet Temp/RH sensor is open, missing, or shorted. Check that inlet temp/RH sensor is
installed correctly on control panel and inlet shroud. If error persists, contact service.
ER6 CONTACT
SERVICE CENTER
Current sensor failure. If error persists, contact service.
ER7 INVALID
MODEL SETTING
Incorrect or unsupported DIP switch settings. Contact Dri-Eaz service department for
correct DIP switch settings.
ER8 BUTTON STUCK
ALL BUTTONS
Key is stuck or has been held down too long. Contact service.
ER9 PUMP BLOCKED
PUMP & HOSE
Check for obstructions in drain hose. Check the pump.
SPECIFICATIONS
Model
LGR 2800i F410
LGR 3500i F411
Use weight
160 lbs. | 72.6 kg
160 lbs. | 72.6 kg
Dimensions
(H × D × W)
40.5 × 23 × 24 in.
103 × 58 × 61 cm
40.5 × 23 × 24 in.
103 × 58 × 61 cm
Power
8.0 amps,
120 volts
11.2 amps,
120 volts
Water removal
AHAM (80°F/60%
RH)
130 pts. | 61.5 liters /
day
170 pts. | 80.4 liters /
day
Water removal max.
(90°F/90% RH)
200 pts. | 94.6 liters /
day
240 pts. | 113.6 liters
/ day
Water removal
80°F/20% RH
20 pts. | 9.5 liters /
day
24 pts. | 11.4 liters /
day
Max process air
400 CFM | 679.7
CMH*
400 CFM | 679.7
CMH*
Operating range
33125°F | 152°C
33100° F | 138° C
Construction
Rotomolded shell
Rotomolded shell
Safety
ETL certified to CSA
22.2 no. 92
ETL certified to CSA
22.2 no. 92
Specifications are subject to change without notice. Some values may
be approximate. *Automatic variable speed for optimized
performance.
PARTS INCLUDED
40 ft. (12 m) of drain hose with quick-connect fitting.
25 ft. (7.6 m) detachable power cord.
3M™ HAF filter (reorder F527 24 pk.)
ACCESSORIES
VMax Adaptor (F422)
Sto&Go Ducting (F405)
FOR PARTS AND SERVICE CALL YOUR LOCAL
DISTRIBUTOR or Dri-Eaz at 800-932-3030. Visit
warranty.DriEaz.com and register your purchase to
ensure you receive any important product releases.