User Manual

ManualsBrandsDri-Eaz ManualsDehumidifiers & DesiccatorsDri Eaz® Command Hub Field Retrofit Kit for Dehumidifier w/Sensor, 2-5/6"W x 7"D x 1-1/3"H

Table Of Contents

124506B 1

Dri-Eaz® Dehumidifier Command Hub Installation

Special Instructions for 2800i and 3500i Models

Legend Brands, Inc.

15180 Josh Wilson Road, Burlington, WA 98233

Phone: 800-932-3030 Fax: 360-757-7950 LegendBrandsRestoration.com

Below are the steps required to install the Command Hub in 2800i and 3500i dehumidifiers.

Find these instructions and more information on the Command Hub at

DehuCommandHub.LegendBrandsRestoration.com

Step 1

Unplug or disconnect power to the dehumidifier.

Using a #2 Philips screwdriver, remove the 4 mounting

screws – set aside and save to secure the Command Hub.

Step 2

Lift out the old i-Series controller and remove the 4 cables

from the back – 2 temp sensors and 1 data cable.

Step 2a

Use a 1/16" drill bit to drill a pilot hole roughly 1/4" above

the air inlet hole (see photo). IMPORTANT: Do not drill

more than 1/4" past the plastic to prevent drilling into the

filter behind the inlet.

Step 2b

Remove and discard the plastic stud that is connected to

the sensor included with this kit.

Summary of content (4 pages)

PAGE 1
Dri-Eaz® Dehumidifier Command Hub Installation Special Instructions for 2800i and 3500i Models Legend Brands, Inc. 15180 Josh Wilson Road, Burlington, WA 98233 Phone: 800-932-3030 Fax: 360-757-7950 LegendBrandsRestoration.com Below are the steps required to install the Command Hub in 2800i and 3500i dehumidifiers. Find these instructions and more information on the Command Hub at DehuCommandHub.LegendBrandsRestoration.com Step 1 Unplug or disconnect power to the dehumidifier.
PAGE 2
Step 2c Using the #4 screw included in the kit, screw the sensor into the pilot hole with the center of the sensor directly over the air inlet. Note: Be sure that the wire connector is facing up, not down. #4 screw Sensor Center Connector facing up Step 3 Connect the cables to the Command Hub as shown. Take care not to tangle or twist the cables and ensure the controller is oriented correctly. Connect the four cables to the new controller as follows: 1. Temp/RH connector to K3/RH1 receptacle.
PAGE 3
Step 4 Place the Command Hub into position and, to avoid stripping mounting holes, hand-tighten the 4 screws that were removed from the previous i-Series controller in Step 1. Once the controller is secured to the dehumidifier, plug in the unit. The first Config screen will display after a brief start-up cycle. Enter the serial number of the dehumidifier from the serial label on the unit.
PAGE 4
Step 7 Once you have finished configuring the serial number, model, time, and date, you will see the Home screen in OFF mode. The dehumidifier is ready to be powered on by pressing the Power button: When switched ON, the Home screen displays inlet temperature/relative humidity (RH), outlet temp/RH, date, time, Bluetooth connection, and these operation buttons in the lower section: menu, purge and on/off. The old controller may now be discarded in a facility that accepts electronic waste.