Instruction manual

9
INSTALLATION
SAFETY FIRST!
Install DashDAQ in such a manner that it does not interfere with the safe operation of the vehicle. If DashDAQ cannot be mounted in
such a manner, promptly return the DashDAQ, in new and unused condition, with a dated proof of purchase, to the place of purchase
for a full refund less a 20% restocking fee.
OBDII CONNECTOR
The OBDII or “data link” connector is necessary for DashDAQ operation in OBDII vehicles. Power and all vehicle information come
directly from this vehicle link. Some custom applications (aftermarket ECMs, aftermarket data acquisition equipment, etc.) may not
have an OBDII connector in the vehicle. In these cases the connection between the vehicle and DashDAQ is application specific.
Most OBDII connectors are found directly below the steering column. It should be in plain sight. If you cannot find the OBDII connector
have a local mechanic show you where it is.
CABLE ROUTING
The DashDAQ OBDII cable must be routed so that it does not interfere with safe operation of the vehicle.
Cable routing tips:
• Find the OBDII connector first and work the cable to where DashDAQ is to be mounted on the windshield.
• Route the DashDAQ OBDII cable between interior panel grooves to hold the cable as well as conceal it.
• Use wire or zip ties to bundle any excess cable.
Cable routing “Don’ts”
• Don’t let the cable dangle by your feet.
• Don’t let the cable hang free.
• Keep the cable away from the steering wheel and any steering column controls.
• Golden Rule: If the cable looks to be poorly routed, it is. Reroute it.
ATTACHING WINDSHIELD MOUNT
1. Remove these two items from packaging:
a. Display Unit
b. Windshield Mount
2. Line up the four holes on the windshield mount and thread each of the four screws into the display unit.
3. Using a Phillips head screwdriver, lightly tighten each of the four screws. Note: Over-tightening can possibly damage DashDAQ.
Tighten the screws so they are snug, no more.