Instruction manual

40
Figure 36: Tap [Save] to confirm the device installation Figure 37: New signals will be available on E-ChryslerSpecific
Now that we see the Chrysler Specific driver populated in slot [E], we will now be able to view the Chrysler specific parameters on any
gauge after we run “Find Signals” again.
ADJUSTING DRIVER PARAMETERS
Parameters menu is used to customize how data is display, for example changing the units to metric, to change signal scaling, and other
options.
1. From the main menu, tap on [Setup]
2. Tap on [Devices]
3. Tap on [Parameters]
Enhanced Drivers can also be modified through Main Menu>Devices>Parameters so that more or less parameters are searched for
through “Find Signals.” Each enhanced driver for each manufacturer has thousands of parameters. We organized these parameters into
a scale of usefulness:
0: Most Useful, Less parameters
1: Less Useful, More parameters
2: Even less Useful, Lots of parameters
To change the amount of parameters you will search for on an enhanced driver:
1. Make sure the enhanced driver is installed in the Device Manager, and a “Find Signals” (Section 0) procedure has been
performed once.
2. From the Main Menu tap on [Setup], then [Devices], then [Parameters].
3. Use the [<] or [>] buttons at the top to find your enhanced driver.
4. Tap on [Complete Signal List] to highlight and tap [Change].