Instruction manual

11
WARNING: Do not power DashDAQ from the PC with the USB ports on the right. Permanent damage to your DashDAQ can occur.
SD MEMORY CARD
Always insert and remove the memory card with the DashDAQ powered off. Insert the card with the gold connections facing towards
the screen. Press the card into the DashDAQ until a click is heard. If the card sticks out at all, it has not been pushed in all the way.
To remove, press the card in until a click is heard. Release, and the card will eject enough to grab it.
BASIC OPERATION
OFF / ON / LOW POWER MODE
The Off / On/ Low Power mode button is located on the front left corner of the DashDAQ. It has three functions:
• To shut off DashDAQ: Press the button and hold for 3 seconds. A screen will say “Shutting Down.” The screen will go black. The
DashDAQ is completely off.
• To turn on DashDAQ: Press the power button again to power the DashDAQ back up.
USB Ports
Power Button
MMC SD Memory
Card Slot
Light Sensor