Instruction manual

31
6. To select the Innovate LC-1, use the [<] or [>]
buttons to navigate to the “Wideband”
selection.
7. Tap [Innovate LC-1] to highlight the Innovate
LC-1 driver. Tap [Save].
8. Tap [Save] again. Tap [Save] once more at
the Installed Device setup window.
32
To make use of the driver after it has been
selected:
1. Tap on [Gauges] from the Main Menu.
2. Tap on a gauge you would like to assign the
Innovate LC-1 signal to.
3. Tap [Assign Signal].
4. Use the [<] or [>] buttons to navigate to the
Innovate LC-1 heading. Tap [Air-Fuel Ratio]
to highlight.
5. Tap [Save]. Tap [Save] again at the Assign
Signal Screen.
This procedure can be repeated for all drivers
found in the Installed Devices setup option.