User manual

User Manual
Version 01.01
2011-07-01
USB radio sticks deRFusb
dresden elektronik
ingenieurtechnik gmbh
Enno-Heidebroek-Str. 12
01237 Dresden / Germany
Tel.: 0351 – 31 85 00
Fax: 0351 – 3 18 50 10
[e-mail]
www.dresden-elektronik.de
Page 19 of 25
10. Radio certification
10.1. United States (FCC)
The deRFusb-23E00/06/JTAG and deRFusb-13E00/06/JTAG USB radio sticks comply with
the requirements of FCC part 15.
The FCC certification for deRFusb-13E00/06/JTAG is pending.
To fulfill FCC Certification requirements, an OEM manufacturer must comply with the follow-
ing regulations:
The modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is
not visible when the module is installed inside another device, the outside of the device into
which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following. Any similar wording that expresses
the same meaning may be used.
Sample label for USB radio stick deRFusb-23E00, deRFusb-23E06,
deRFusb-23E00 JTAG and deRFusb-23E06 JTAG:
FCC
-
ID: XVV
-
ARM323E00
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
Note: The usb radio sticks deRFusb-23E00 JTAG, deRFusb-23E06 and deRFusb-23E06
JTAG fulfill a Permissive Change Class 1 regarding to FCC Section 2.1043 and complies
with the requirements of FCC part 15.
The Original Equipment Manufacturer (OEM) must ensure that the OEM modular transmitter
is labeled with its own FCC ID number. This includes a clearly visible label on the outside of
the final product enclosure that displays the contents shown below. If the FCC ID is not visi-
ble when the equipment is installed inside another device, the outside of the device into
which the equipment is installed must also display a label referring to the enclosed equip-
ment.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
(FCC 15.19). The internal / external antenna(s) used for this mobile transmitter must provide
a separation distance of at least 20 cm from all persons and must not be co-located or oper-
ate in conjunction with any other antenna or transmitter.
Installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance. This device is approved as a mobile de-