Programming instructions

Atmel AT02597: ZigBee PRO Packet Analysis with Sniffer [APPLICATION NOTE]
32210A−WIRELESS−09/2013
5
1.2 BitCatcher
Luxoft BitCatcher ZigBee Network Analyze tool is a simple and flexible protocol analyzer that can be used to analyze
standard IEEE 802.15.4 and ZigBee frames using Atmel hardware sniffing tools in the sub-GHz and 2.4GHz frequency
bands.
1.2.1 Setup Information
The sniffer PC tool can be downloaded from [3].
The package also comes with the firmware files and drivers for the supported sniffer hardware:
• Atmel AVR
®
RZUSBSTICK
• Dresden Elektronik deRFusb-23E00 (2.4GHz) and deRFusb-13E00 (Sub-GHz)
Once installed, sniffer device can be configured for use with the sniffer PC tool as below.
• Plug in the sniffer hardware (e.g.: RZUSBSTICK) to a free USB port in the PC
• Flash the sniffer firmware image to the MCU on the sniffer hardware, if not pre-programmed
Caution: For the RZUSBTICK, the fuse settings shall be:
Extended: 0xFB, High: 0x91, Low: 0xDE
• The firmware images for the RZUSBSTICK and the deRFUSB is available as .hex files in the directory
\embedded inside the BitCatcher package
• Un-plug and plug the device into the USB port once again. Install the driver provided in the sniffer package
when prompted for
• The sniffer drivers are available in the directory \driver inside the BitCatcher package
• After driver installation, the device will be listed in the Windows Device Manager as shown in Figure 1-4
Figure 1-4. Sniffer Devices Listing in Windows Device Manager.