Programming instructions

Atmel AT02597: ZigBee PRO Packet Analysis with Sniffer [APPLICATION NOTE]
32210A−WIRELESS−09/2013
4
1.1.1 Setup Information
To setup the capture session using Wireshark, download the Atmel Wireshark Interface from Atmel Gallery [7].
Wireshark version Wireshark-win32-1.8.0 or lesser shall be installed on the PC [8].
Figure 1-3. Atmel Wireshark Interface in Atmel Gallery.
• The package is installed in directory \Atmel\AtmelWiresharkFirmware
• Follow the instructions in the Readme_Important_Atmel_Wireshark_Sniffer_Interface.txt to
complete the setup procedure
• The sniffer firmware to be flashed on the respective hardware platforms, RZUSBSTICK and RZ600 are
provided as images (Wireshark_Sniffer_Raven.hex and Wireshark_Sniffer_RZ600.elf) in the
package
• Refer to [4] and [2] for programming instructions
Caution: For the RZUSBTICK, the fuse settings shall be:
Extended: 0xFB, High: 0x91, Low: 0xDE
• This version of the Wireshark capture interface (v1.0) does not support sub-GHz sniffer tools
• The USB drivers available with the package support Windows
®
XP/2000/7 and are automatically loaded to
Windows by the installer.
Chapter 2 p
rovides further information on setting up a capture session for the Wireshark Interface.