User's Manual

User Manual
Version 01.01
2011-12-22
Radio modules deRFarm7
dresden elektronik
ingenieurtechnik gmbh
Enno-Heidebroek-Str. 12
01237 Dresden / Germany
Tel.: +49 351 – 31 85 00
Fax: +49 351 – 3 18 50 10
[e-mail]
www.dresden-elektronik.de
Page 33 of 38
ble when the equipment is installed inside another device, then the outside of the device into
which the equipment is installed must also display a label referring to the enclosed equip-
ment.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
(FCC 15.19). The internal / external antenna(s) used for this mobile transmitter must provide
a separation distance of at least 20 cm from all persons and must not be co-located or oper-
ated in conjunction with any other antenna or transmitter.
Installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance. This device is approved as a mobile de-
vice with respect to RF exposure compliance, and may only be marketed to OEM installers.
Use in portable exposure conditions (FCC 2.1093) requires separate equipment authoriza-
tion.
Modifications not expressly approved by this company could void the user's authority to
operate this equipment (FCC section 15.21).
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasona-
ble protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference
at his own expense (FCC section 15.105).
11.2. European Union (ETSI)
The deRFarm7-15A02, deRFarm7-15C02, deRFarm7-25A00, deRFarm7-25C00, deRFarm7-
25A02 and deRFarm7-25C02 modules have been tested compliant for use in European Un-
ion countries.
If the deRFarm7-15A02, deRFarm7-15C02, deRFarm7-25A00, deRFarm7-25C00, deR-
Farm7-25A02 and deRFarm7-25C02 modules are incorporated into a product, the manufac-
turer must ensure compliance of the final product to the European harmonized EMC and low-
voltage/safety standards. A Declaration of Conformity must be issued for each of these
standards and kept on file as described in Annex II of the R&TTE Directive.
The manufacturer must maintain a copy of the deRFarm7-15A02, deRFarm7-15C02, deR-
Farm7-25A00, deRFarm7-25C00, deRFarm7-25A02 and deRFarm7-25C02 modules docu-
mentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of the-
se specifications are exceeded in the final product, a submission must be made to a notified
body for compliance testing to all required standards.
The “CE“ marking must be affixed to a visible location on the OEM product. The CE mark
shall consist of the initials "CE" taking the following form: