DREMEi Moto-Tool Models o ° Owner's Manual 275, 285, 395 -2 HONESTLY OWNER'S NOW... MANUAL? Have you read this This manual will tell you how to get the most out of your new Moto-Tool. It will give youtips on some of the many different do-it-yourself jobs the tool will perform around your home and workshop. WARNING assembly • operation • safety OREMEL 1/88 5296077 For your own safety read your Owner's Manual instructions. before operating your Dremel Moto-Tool _.o.
For Your Safety... READ 1. Keep work area and benches invite clean -injuries. AND Cluttered areas 2. Avoid dangerous environment -Don't expose tools to rain. Don't use power tools in damporwetlocations. Don't use power tools in the presence of flammable liquids or gases. Avoid chemical or corrosive environments Keep work area welt lit. 3. Guard against electric shock -- Prevent body contact with grounded surfaces. For example: pipes, radiators, refrigerator enclosures. 4.
introduction The Moto-Tool is a handful of high-speed power. It serves as a carver, a grinder, polisher, sander, cutter, power brush, drill and more. The Mote-Tool has a small, powerful electric motor, is comfortable in the hand. and is made to accept a large variety of accessories including abrasive wheels, drill bits, wire brushes, polishers, engraving cutters, router bits, and cutting wheels. Accessories come in a variety of shapes and permit you to do a number of different jobs.
Operation Guidelines Read the next sections carefully. They will help you use your MolD-TOOl correctly and help you select the correct accessory for your job. Using the Moto-Tool The first step in learning to use the Moto-Tool is to get the "feel" of it. Hold it in your hand and feel its weight and balance. Feel the taper of the housing. This taper permits the Moto-Tool to be grasped much like a pen or pencil.
Operating Speeds Set the speed indicator to fit the job - To achieve the best job results when working with different materials, the speed of the Moto-Tool should be regulated. Only a full wave output speed control such as the Dremel Models 217 and 219 should be used with the Model 275. Model 285 and 395 Moto-Tool has an integral speed control and an external speed control should never be used with these tools.
Speed Settings " Speed for light cuts, t" Depending on cutting CATALOG NUMBER I caution direction burning relative on deep to grain. t WOOD WOOD PLJ_STIC HIGH BRASS, SPEED ETO, 5 3 3 2 189.190 5 5 2 4 5 118.191.193 5 5 5 5 2 2 3 3 5 5 5 3 2 2 2 5 5 2 1-2 1-2 197 4 2 2 1 3 198 4 2 2 2 3 199 4 2 1-2 2 121.131.141 114.124,134.144 192,194 118,117,125,196 115,178 SMALL 105.
Moto-Tool Accessories The number and variety of accessories for the Moto-Tool are almost limitless. There is a category suited to almost any job you might have to do--and a variety of sizes and shapes within each category which enables you to get the perfect accessory for ever,,, need. Refer to the DREMEL BITS OF INFORMATION ACCESSORY ORDER FORM for illustratiorts of ttte acces_orie-J available. These accessories may be found at your local hardware, hobby or home center dealers.
Maintenance MAJNT'ENANCE Models 275,285, OF REPLACEABLE & 395 Information BRUSHES The brushes should be inspected frequently when tools are used continuously. If your tool runs s_oradicatly, loses power, makes unusual noises or runs at a reduced speed, check the brushes. To continue using the tool in this condition will permanently damage your tool.
