SDS

SAFETY DATA SH EET
Page 3 of 5
OSHA PEL and ACCIH TWA during handling and use.
Personal Protection/Respirator:
Where engineering controls cannot be provided a NIOSH/MSHA approved respirator for dust’s having
a TWA not less than 0.05 MG/M3 should be used during buffing operations. Respiratory protection is
usually not required during normal storage and handling
Protective Clothing:
For normal handling of unused product wear safety glasses and observe normal good hygiene, such as
frequent washing of exposed areas and a daily change and laundering of clothing. During buffing the
use of a face shield, cloth gloves, and cloth apron is recommended.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point ……………………..Not Applicable
Vapor Pressure …………………...Not Applicable
Vapor Density ……………………Not Applicable
Evaporation Rate …………………Not Applicable
Solubility in water ………………..Not Applicable
Percent Volatile …………………..Not Applicable
pH ………………………………...Not Applicable
Viscosity ………………………….Not Applicable
Melting Point ……………………..Not Applicable
SECTION 10: STABILITY AND REACTIVITY
Stability:
Stable
Incompatibility;
Materials/conditions to avoid: Not Applicable
Hazardous Polymerization:
Hazardous polymerization will not occur.
Hazardous Decomposition Products:
No hazardous decomposition products are expected during normal use of this product. However, during
flaming conditions or excessive heating the following may be emitted: Carbon Monoxide, Carbon
Dioxide, Oxides of nitrogen, cyanides, formaldehyde
SECTION 11: TOXICOLOGICAL INFORMATION
Eye Protection:
Wear safety glassed with side shields. Use protective glasses and/or face shield as recommended: in
ANSI Standard Z87.1.
Skin Protection:
Not Applicable
Recommended Ventilation:
Provide appropriate local exhaust for grinding, cutting or sanding cured material. If exhaust ventilation
is not adequate, use appropriate respiratory protection. Use particulate collection systems.
Respiratory Protection:
Avoid breathing of dust created by cutting, sanding or grinding. Select one of the fallowing NIOSH
approved respirators based on airborne concentration of contaminant and in accordance with OSHA
regulations: half-mask dust respirator, full-face dust respirator.
Prevention of Accidental ingestion:
Do not ingest.
Recommended Storage:
Not Applicable