SDS

SAFETY DATA SH EET
Page 2 of 5
Filler
30.3
Antiager
9.2
SECTION 4: FIRST AID MEASURES
Inhalation:
If signs/symptoms occur, remove person to fresh air. If signs/symptoms continue, call a physician.
Eye Contact:
Immediately flush eyes with plenty of water for 15 minutes. If abrasive particles are not removed by
flush, obtain medical attention.
Skin Contact:
Wash with soap and water. Wash clothing daily, imbedded abrasive particles can abrade skin resulting
in irritation
Ingestion:
Swallowing less than an ounce will not cause significant harm. For larger amounts do not induce
vomiting, but give two 12 ounce glasses of water and obtain medical advise.
SECTION 5: FIREFIGHTING MEASURES
Flashpoint and Method:
Not applicable
Flammable Limits:
Not applicable
Autoignition Temperature:
Not applicable
Extinguishing Media:
Water, carbon dioxide, dry chemical, foam
Special Fire Fighting Procedures:
Wear full protective clothing, including helmet, self-contained, positive pressure or pressure demand
breathing apparatus, bunker coat and pants, bands around arms, waist and legs, face mask, and
protective covering for exposed areas of the head.
Unusual Fire and Explosion Hazards:
Not applicable
NFPA HAZARD CODES:
Health: 1, Fire: 0, Reactivity: 0, Unusual Reaction Hazard: none
SECTION 6: ACCIDENTAL RELEASE MEASURES
Sweep or scoop up material for reuse or reclaim if possible; otherwise place in a disposal container for proper
disposition. Do not flush to sewers or waterways unless authorized to do so by appropriate government official
SECTION 7: HANDLING AND STORAGE
Storage Temperature:
Ambient
General:
Keep out of sun and away from heat sources, as product may melt. Observe all safeguards for container
residue until cleaned or destroyed
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Controls:
Local exhaust ventilation should be provided to maintain the airborne exposure to personnel below the