SDS

5
Material Safety Data Sheet
SECTION 8: EXPOSURE ECONTROL/PERSONAL PROTECTION
Engineering Controls:
Local exhaust ventilation should be provided to maintain the airborne exposure to personnel below the OSHA PEL and ACCIH
TWA during handling and
use
Personal Protection/Respirator:
Where engineering controls cannot be provided a NIOSH/MSHA approved respirator for dust's having a TWA
not
less than 0.05 MG/M3 should be used during buffing operation's. Respiratory protection is usually not required
during normal storage and handling
Protective Clothing:
For normal handling of unused product wear safety glasses and observe normal good hygiene, such as
frequent
washing of exposed areas and a daily change and laundering of clothing. During buffing the use of a face shield,
cloth gloves, and cloth apron is recommended.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point N/A
Vapor Pressure N/A
Vapor Density N/A
Evaporation Rate N/A
Solubility In water N/A
Percent Volatile N/A
PH N/A
Viscosity N/A
Melting Point N/A
SECTION 10: STABILITY AND REACTIVITY
Stability: Stable
Incompatibility; Materials/conditions to avoid: Not
Applicable
Hazardous Polymerization: Hazardous polymerization will not
occur.
Hazardous Decomposition Products: No hazardous decomposition products are expected during normal use of
this
product. However, during flaming conditions or excessive heating the following may be emitted: Carbon Monoxide,
Carbon Dioxide, Oxides of nitrogen, cyanides, formaldehyde
SECTION 11: TOXILOGICAL INFORMATION
Eye Protection: Wear safety glassed with side shields.
Use protective glasses and/or face shield as recommended in ANSI Standard
Z87.1.