Safety data sheet

MATERIAL SAFETY DATA SHEET
Copper Harbor Company, Inc. Page 3 of 8
Date Prepared: 07/21/10
Date Printed: 3/28/11
MSDS No.: 0252-09
Product: G.A.L.CUTTING OIL ** Dremel PN 2610008485
Spill Response Procedures:
Combustible, keep all sources of ignition away from spill. Stay upwind and away from spill.
Isolate hazard area and limit entry to authorized personnel. Stop spill if it can be done without
risk. Wear appropriate protective equipment including respiratory protection as conditions
warrant. Wear respirator with organic vapor canisters. Prevent spilled material from entering
sewers, storm drains, other unauthorized treatment drainage systems and natural waterways.
Dike far ahead of spill for later recovery or disposal. Spilled material may be absorbed into an
appropriate absorbent material. Notify fire authorities and appropriate federal, state and local
agencies. Clean up immediately.
7. PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Ventilation and engineering controls: Must be calibrated for air flow and removal of standard
contaminant from workplace air.
Other handling and storage requirements: Store product in tightly sealed containers in cool
and dry place.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Respiratory Protection:
Use in a well-ventilated area only.
Ventilation:
Local Exhaust: Necessary
Special: Not Determined
Mechanical (General): Recommended when used indoors or a prolonged basis
Other: Not Determined
Protective Gloves:
Necessary
Eye Protection:
Necessary
Other Protective Clothing or Equipment:
Wear apron, boots and a face shield with safety glasses. A full impermeable suit is
recommended if exposure is possible to large portion of body.