Specifications

Page 11
#1 Pencil grip – For best control of the Stylus, hold
the tool like a pencil between your thumb and
forefinger.
#2 Side grip – Rotate the tool sideways, with the han-
dle pointing out while resting your hand on the table.
#3 reverse grip – An alternative grip is the reverse
grip for close up applications.
#4 Stable grip – For ultimate stability, rest the
handle of the tool on the table to help stabilize and
control the accessory.
Operating Speeds For Accessories
Adjust the speed dial to achieve the best job results
when working with different materials.
To select the right speed for each job, use a practice
piece of material. Vary speed to find the best speed
for the accessory you are using and the job to be
done.
Your Stylus is equipped with a variable speed dial
from 5,000 – 25,000 rpm. To turn it on, press and
hold the on/off switch until tool turns on. Note, there
is a delayed start to prevent accidentally starting this
tool. It is important that you press the button until the
tool turns on (approximately half a second.) Adjust
the speed of the tool by turning the speed control dial
located at the rear of the tool. T
o turn the tool off,
press the on/off button.
You can refer to the charts on page 13, 14, and 15 to
determine the proper speed, based on the material
and accessory being used. These charts enable you to
select both the correct accessor
y and the optimum
speed at a glance.
DREMEL
DREMEL
ON/OFF
BUTTON
DREMEL
SPEED
CONTROLLER
DM 2610930085 11-05 11/30/05 2:56 PM Page 11