User manual

- 25 -

Notice:

1）Click “Apply” button after finished your setting, IP Phone will save the setting automatically

and new setting will take effect.

2）If you modify the IP address, the web will not response by the old IP address. Your need

input new IP address in the address column to logon in the phone.

3）If networks ID which is DHCP server distributed is same as network ID which is used by

LAN of system, system will use the DHCP IP to set WAN, and modify LAN’s networks

ID(for example, system will change LAN IP from 192.168.10.1 to 192.168.11.1) when

system uses DHCP client to get IP in startup; if system uses DHCP client to get IP in

running status and network ID is also same as LAN’s, system will refuse to accept the IP to

configure WAN. So WAN’s active IP will be 0.0.0.0

4.3.2.2. LAN Config

LAN Confi

Field name explanation

LAN IP Specify LAN static IP.

Netmask Specify LAN Netmask.

DHCP Service

Select the DHCP server of LAN port or not. After you modify the

LAN IP address, phone will amend and adjust the DHCP Lease

Table and save the result amended automatically according to the

IP address and Netmask. You need restart the phone and the DHCP

server setting will take effect.

NAT Select NAT or not.

Bridge Mode

Select Bridge Mode or not: If you select Bridge Mode, the phone

will no longer set IP address for LAN physical port，LAN and WAN

will join in the same network. Click “Apply”, the phone will

reboot.

Notice: If you choose the bridge mode, the LAN configuration will be disabled.

4.3.2.3. Qos Config

The VOIP phone support 802.1Q/P protocol and DiffServ configuration. VLAN functionality can

use different VLAN IDs by setting signal/voice VLAN and data VLAN. The VLAN application of

this phone is very flexible.