User manual

- 10 -

IP with PPPoE.

Setting Static IP mode（static ADSL/Cable，or none PPPoE / DHCP network）

1. Prepare the network’s parameters first. IP Address，Netmask， Default Gateway and DNS

server IP address are needed. Please contact the service provider or technician of network.

2. Pressing ，and twice，screen shows“7 Advanced”, then pressing

Soft2(Enter)，screen will show “Enter Password”.

3. Input password（default is 123）and pressing Soft2(Enter)，then pressing twice, now

screen shows “3 Network”。

4. Pressing Soft2 (Enter)，then pressing

,screen shows“2 Static Set”. Pressing Soft2(Enter)

to make screen show“1 IP”，press Soft2(Enter) and then press Soft2(Edit) again, and Soft1(Del)

to delete old parameter. Input your IP address and press Soft2 (Save). After “Saved” shown,

screen will jump to show the IP information currently.

5. Press to show “2 Netmask”. Press Soft2(Enter) and press Soft2(Edit) again，and then

use Soft1(Del) to delete. Input your Netmask and press Soft2 (Save). After “Saved” shown,

screen will jump to show the Netmask information currently.

6. Press to show “3 Gateway”. Press Soft2(Enter) and press Soft2(Edit) again，and then

use Soft1(Del)to delete，Input your gateway and press Soft2(Save). After “Saved” shown, screen

will jump to show the gateway information currentlly.

7. Press to show“4 DNS”. Press Soft2(Enter) and press Soft2(Edit) again，and use

Soft1(Del) to delete. Input your DNS server address and press Soft2 (Save). After “Saved”

shown, screen will jump to show DNS information.

Press twice Soft3 (Quit) quitting. With pressed，screen shows“1 Net Mode”. Press

Soft2(Enter) and press Soft2(Edit) again, and

，screen shows“<>Static”; with Soft2(Save)

pressed，screen shows “Saved” and then shows the net mode currently.

9. Press Soft3 (Quit) four times to quit to stand-by status. Press to show “Static”. If

screen shows the IP address and gateway which are set just now, it shows that Static IP mode is

taken effect.

Setting DHCP mode

Press and twice，screen will show“7 Advanced”. Then press Soft2(Enter)，

screen will show “Enter Password:”.

2. Input password（default is 123）and press Soft2(Enter)，and press twice, then screen