Specifications

11UNIDOOR TOULON manual Ver 1 Rev 1 07/2018

TIP: Position the hinge-side bottom

spacer approximately 4” away from the

hinge side of the glass to allow for easy

removal after the door is installed.

Fig 2

5/8” spacer

±0.0

5/8"

Never set the glass down directly onto a tile or concrete floor. Always use a

piece of wood or cardboard and leave the corner pads and protective shims

on the glass until it becomes necessary to remove them. This will protect the

bottom edge and corners from damage which could lead to breakage.

2. Set the Door Glass (#01) (with two 5/8” spacers attached to the bottom) onto the threshold at the

desired location and check for level. The provided 5/8” spacers will leave the proper spacing at the

bottom of the Door Glass (#01). Carefully position the Door Glass (#01) with the hinge side against the

wall, adjust its position and check for plumb with a level before marking the hinge positions. (Fig 2)

NOTE: Use a tape measure to confirm that the installed height of the Door Glass (#01) will

match the height of the Stationary Panel Glass (#11) before marking the hinge locations.