Installation Guide

Parts Needed

Roller Assembly Adjustment Procedure

Glass to make contact with the Bottom Guide Rail (#15). [see Page 28]

Always take precautions when handling tempered glass.

ENCORE Shower and Tub Door Manual Ver 1 Rev 6 04/2019 28

To adjust the Door Glass with the Roller Assemblies:

1. Remove the Roller Assembly Cover Plate

2. Loosen the mounting bolt

3. Rotate the adjustment bolt:

-Counter-clockwise to raise

-Clockwise to lower

Do Not remove the bolts or fully disassemble the Roller Assemblies.

mounting bolt

(Do Not Remove)

adjustment bolt

(Do Not Remove)

cover plate

outside

shower

Do Not allow the Door Glass to make contact with the

Bottom Guide Rail during this process.

NOTE

Use the adjustment bolt on the Roller Assembly to adjust

the Door Glass so it closes evenly into the Wall Profiles.

Fig 1

Fig 3

Fig 2