Installation Sheet

Product Maintenance

ENCORE Maintenance Checklist

◻ Top Guide Rail level and tight

◻ Wall Profiles and Guide Rail Brackets tight to the walls

◻ All screws are tight

◻ Both lites of Door Glass are secure and level

◻ Guide Block square to the threshold and glass

◻ Bottom Guide Rail secured to the threshold

◻ Bottom Guide Rail screws are tight

◻ Proper clearance beneath the door glass between the bottom rail and within the guide block

◻ Door Glass adjusted so that the SafeClose™ Bumpers smoothly catch and release the glass

during operation

◻ Roller Assemblies tight

◻ Roller Assembly cover plates secure

◻ Roller Assembly adjustment bolts tight

◻ Towel Bar screws are tight and secured to each door and gaskets are in place to prevent glass-to-

metal contact

◻ Both doors operate smoothly through the guide block and do not make contact with one another

◻ Inspect and replace silicone as necessary to prevent water leakage

To maximize the life of your door, it is important to regularly inspect

the glass and other hardware for misalignment, proper attachment,

and/or damage. Contact DreamLine

with any questions or concerns.

NOTE

BASES and BACKWALLS: To ensure long lasting life for your acrylic back walls: wipe them off

after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream

based cleaners. Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal

brushes or scrapers that could permanently scratch or dull the surface.

GLASS: To ensure long lasting life for your glass shower products: wipe them off after each use

with a soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent

soap buildup and water spots (Hard water can etch the surface of the glass over time if left to dry).

To prevent scratching the surface: never use abrasive cleaners or cleaning products that contain

scouring agents. Never use bristle brushes or abrasive sponges that may scratch the surface of the

glass.

HARDWARE: To ensure a long lasting finish: wipe off all metal parts after each use with a soft

cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If

accidentally used, rinse the surface as soon as possible to prevent damage to the finish (peeling or

corrosion). After cleaning the polished finishes, rinse thoroughly and wipe dry with a soft clean-

cloth.

Clean stainless steel surfaces at least once a week. When applying stainless steel cleaner or polish

to stainless steel hardware, work with the grain (not across the grain). Never use an abrasive

sponge or cloth, steel wool or wired brush as these may permanently scratch the surfaces.

ENCORE Shower and Tub Door Manual Ver 1 Rev 6 04/2019 26