Installation Guide

11CHARISMA manual Ver 3 Rev 4 10/2016
Ø 1/8"
Ø 1/8"
Ø 1/8"
Fig 11
1
2
3
4
Fig 12
5
6
1 2
3
4
7
outside
outside
10. Install the Guide Rail (#01) over the top
of the Guide Rail brackets (#11) and lock
them together. Mark the drill holes in the
underside of the Guide Rail (#01) through the
holes in the bottom of the bracket. Remove
the Guide Rail (#01) and drill the holes using
an Ø1/8” drill bit.
Before attaching the Guide Rail (#01) to the
Guide Rail brackets (#11):
Slide two Roller assemblies (#10) into each
channel of the Guide Rail (#01) with the
finished surface of the disks facing out.
(Fig 11.6, 11.7)
See Fig 11 for details
11. Place the Guide Rail (#01) back into position on
the Guide Rail Brackets (#11) and fasten the Guide
Rail (#01) to the Guide Rail Brackets (#11) with the
Round Head Screws ST4.2×10 (#16).
See Fig 12 for details