Installation Guide

Q-Wall Tub manual Ver 1 Rev 2 11/2017

Fig 19b

Fig 19a

Fig 20

1 2

Wall Profile

Side Panel

Wall

Side Panel

Wall Profile

19. Slide the edge of the Side Panel (#01) behind the Corner Cover (#04) and push the Side Panel

(#01) flat against the wall up to the vertical reference line toward the outside of the tub (Fig. 19a.3).

Align the top of the Side Panel (#01) with the Back Panel (#02) before the adhesive sets. Apply equal

pressure to the whole surface of the Side Panel (#01) from top to bottom.

*Peel off the adhesive tape on the back side of the Decorative Edge Molding (#03) and attach it to the

front edge of the Side Panel (#01). Apply pressure to the Decorative Edge Molding (#03) from top to

bottom. (Fig 19a)

TIP:

*If also installing a shower door, the wall profile

can be installed to hide the edge of the

Side Panel (#01) behind the wall profile and not use

the Decorative Edge Molding (#03). (Fig 19b)

20. Apply adhesive to the entire back surface of the Side Panel (#01)

for the opposite side wall installation. Use the same technique to apply

pressure over the entire surface and make the top edge even with the

adjacent acrylic wall panel. (Fig 20)