Installation Guide

Q-Wall Tub manual Ver 1 Rev 2 11/2017

Fig 15

Fig 16b

Fig 16a

this edge

to outside

these edges

to the corners

this edge

to outside

16. Place the Side Panel (#02) onto a flat piece of plywood or

particle board. Use a T-square and a sharp industrial knife to

score along the cut lines (from the previous step) on the Side

Panel (#02) and continue scoring until fully cut through the

panel. (Fig 16a and Fig 16b)

15.

Mark the finished cut size “S” for both Side

Panels (#01).

NOTE:

(a) = Narrow edge (3-3/8”) toward the corner

reference line (do not trim this edge)

(b) = Wider edge (6-3/8”) toward the outside of the

side wall. (trim this edge only)

Trim the side panels to the “S” dimension, cutting

from the wider edge (b) of the side panels only.

Place a mark on the wider edge (b) of the Side

Panel (#01) to the dimension of S from the corner

side of the Side Panel (#01) to the front edge and

draw a straight cut line from top to bottom. (Fig 15)