Installation Guide

Q-Wall Tub manual Ver 1 Rev 2 11/2017

Fig 8a

Fig 8b

Fig 10

Fig 9

8. Place the Back Panel (#02) onto a flat piece of

plywood or particle board. Use a T-square and a sharp

industrial knife to score along the cut lines (from the

previous step) on the Back Panel (#02) and continue

scoring until fully cut through the panel.

(Fig 8a and Fig 8b)

10. Apply adhesive to the entire back surface

of the left Back Panel (#02). (Fig 10)

9. Install the Center Cover (#05) to the center of

the back wall using the Countersunk Screws

ST4.2×30 (#07). Do not fully tighten the screws

yet. Leave the Center Cover (#05) loose on the

wall for now. (Fig 9)