Installation Guide

Q-Wall Tub manual Ver 1 Rev 2 11/2017

Fig 7b

Fig 7a

this edge

to corner

this edge

to corner

these edges

to center

1” reference line

centerline

7. Determine the finished cut size for both Back Panels (#02).

(If the finished overall width of the back wall= 59-1/2” from

corner-to-corner, then it will not be necessary to trim the

back panels. Proceed to Step #9).

NOTE:

(a) = Narrow edge (3-3/8”) toward the center line on the

back wall. (do not trim this edge)

(b) = Wider edge (4-5/8”) toward the corner of the back

wall. (trim this edge only)

Measure the back wall from the 1” reference line in the

corner to the center line drawn in Step# 2. This will be

dimension “L”. Trim the back panel to this dimension,

cutting from the wider edge (b) of the back panel only.

(Fig 7a)

Place a mark on the wider (b) edge of the Back Panel (#02)

with a distance of “L” from the (a) edge of the Back

Panel (#02). Use a straight edge and draw a straight cut line

from top to bottom. (Fig 7b)