Installation Guide

DUET manual Ver.1 Rev 5 11/2016 10
6. Hold the frame in the correct position, mark the
drill holes on the wall through the holes on the
flange of the Wall Profile (#02).
Set the assembled unit aside; drill the holes in the
wall using a Ø5/16” drill bit and insert the Wall
anchors (#07).
See Fig. 8 for details.
7. Apply silicone to the back of the wall profiles, into the drilled holes and
to the bottom of the bottom guide rail prior to attaching to the opening.
Place the frame back into position and secure it to the walls using
Truss Head ST4.2 x 40 screws (#09). Use a level to re-check the
wall profiles for plumb before fully tightening the wall screws.
See Fig. 9 for details.
4
3
2
1
Ø 5/16”
1
2
inside
outside
inside
Fig. 8
Fig. 9