Installation Guide

Rev 1.1
13
14. Determine the position of both Side
panels (01).
NOTE:
a) Narrow side of the Side panel
cannot be trimmed and should face
the corner of the side wall.
b) Wide side of the Side panel can be
trimmed to size of your
measurements and should face the
front of the tub.
Place a mark on the wide side of the
Side panel with a distance of D – 1”
from the corner side of the Side panel
to the front edge and draw a straight
line from top to bottom.
See Fig. 19 for details.
Fig. 19
15. Place the Side panel (01) on a flat piece of
plywood or a particle board. Cut the side end of
the Side panel by making a few deep scratches
with a sharp industrial knife using a T-Square tool
or a handheld jig saw.
See Fig. 20 and Fig. 21 for details.
Fig. 20
D -1”
D -1”
1
2