Installation Guide

Ver. 2, Rev. 1
9
10. Bring the Guide rail (01) over
the top of the Guide rail
brackets (11) and lock them
together.
Mark the drill holes in the
Guide rail through the hole in
the middle of the bracket.
Remove the Guide rail and
drill the holes using Ø 1/8”
drill bit. Slide the Roller
assemblies (10) into the
channel of the Guide rail.
(Two rollers in each slot).
NOTE
:
Pay attention to the direction
of the Roller assemblies
(They all need to face the
same direction as shown in
Figure 10, images 5-6)
Place the Guide rail back into
position and fasten the Guide
rail to the Guide rail bracket with
Fig. 11
the Round head screw ST4.2×10 (17).
See Fig. 11 and Fig. 12 for details.
Fig. 12
1
2
3
4
5
6
Ø 1/8”
7
8