Installation Guide

Ver. 2, Rev. 1
11
12. Slide the Glass doors (03) to the right side
and secure the Left Guide block (13) to the
left end of the Threshold (02).
Drill the holes into the Threshold through
predrilled holes in the Guide block and
fasten the Guide Block with the Round
head screw ST4.2×16 (06).
Slide the Middle Guide block (13) off the
left edge of the Glass doors and secure it to
the center of the Threshold. Drill the holes
into the Threshold using Ø 1/8” drill bit
and fasten the Guide block to it using
Round head screw ST4.2×16 (06).
Now slide the two doors to the left side and
install the Right Guide block (13) to the
right end of the Threshold.
Cover the screws with the Decorative
covers for Guide block (09).
See Fig. 15.1, Fig. 15.2 and Fig. 15.3 for
details.
NOTICE: To align the doors you need to
adjustment the bolts on the rollers.
Fig. 15
13. Press the Bumper strips (14) on the
vertical edges of the Glass doors (03).
See Fig. 15.4 for details.
14. Apply sealant along the connection of
the Guide rail (01) and the Shower
base.
See Fig. 16 and Fig. 17 for details.
Fig. 16
Caulk
1
2
3
4
Ø 1
/
8"